- Inside Contactless programming is not done by the commander, it is programed by the network.
- It will be necessary for the tech to call into the network to program indoor EMV Contactless.
Prior to turning on EMV contactless at the location the correct software must be downloaded to enable the EMV contactless feature.
- Software Base 53.41 Distrib 3.12.47
The following must be performed to update for EMV contactless functionality .
- POS Software Upgrade
- MPD Firmware Upgrade
- Pin pad Firmware Upgrade
Below are the instructions to enable or disable EMV contactless, MAG Stripe Contactless at the Pump with Verifone locations.
This process must be done for each pump to disable or enable followed by a download performed for the forecourt.
- Log- in under Sign manager.
- From CSR Function
- Go to Forecourt
- DCR
- DCR Attributes
- Set Positions- 1 or 2 or 3 …depending on the MPD #
- Go to NFC Mode
- Select one of the off the following functions in the NFC Mode
- Contactless Disabled
- Contactless MSD Enabled
- Contactless EMV Enabled
- Hit Save- ( You are not done.)
- Move onto to the next pump until all pumps have been programed
REMEMBER TO DOWNLOAD TO THE PUMPS
- Go to Forecourt
- Initialize
- DCR
- Hit” all “ if you have programed all pumps or select the designated pump # for the selected change.
Hit Ok.
Test Transaction at each pump.